Adewar: Created page with "If instead of using the bootloader, you want to use a ST-Link you can instead plug your programmer into the 20 pin JTAG connector (J6 on the UFO board): File:Stm32-jtag.jpg..."

2020-03-11T18:05:33Z

Created page with "If instead of using the bootloader, you want to use a ST-Link you can instead plug your programmer into the 20 pin JTAG connector (J6 on the UFO board): File:Stm32-jtag.jpg..."

New page

If instead of using the bootloader, you want to use a ST-Link you can instead plug your programmer into the 20 pin JTAG connector (J6 on the UFO board):

[[File:Stm32-jtag.jpg|600px]]

Then, the details of this step will depend on your programmer. If you're using an ST-Link programmer, open the ST-Link utility and connect to the device:

[[File:Stm32-connect.png]]

Load your `.hex` file and program the device with the Program and Verify button:

[[File:Stm32-program.png]]

After this, you're ready to go - you can use the ChipWhisperer terminal to talk to your target. You might need to reset the target before you do anything else.

CW308T-STM32F/ST Link - Revision history

Adewar: Created page with "If instead of using the bootloader, you want to use a ST-Link you can instead plug your programmer into the 20 pin JTAG connector (J6 on the UFO board): File:Stm32-jtag.jpg..."