Approved_users, bureaucrat, administrator
1,956
edits
| As of August 2020 the site you are on (wiki.newae.com) is deprecated, and content is now at rtfm.newae.com. |
Changes
Created page with "Linux does not require drivers persay, but it does require some setup to allow you to use hardware as a non-root user. The required setup assumes you are using the udev system..."
Linux does not require drivers persay, but it does require some setup to allow you to use hardware as a non-root user. The required setup assumes you are using the udev system. If you are, proceed as follows:
1. Make a file called <code>/etc/udev/rules.d/99-newae.rules</code> . The contents of this file should be:
# allow users to claim the device
SUBSYSTEM=="usb", ATTRS{idVendor}=="2b3e", ATTRS{idProduct}=="ace1", MODE="0664", GROUP="plugdev"
SUBSYSTEM=="usb", ATTRS{idVendor}=="2b3e", ATTRS{idProduct}=="ace2", MODE="0664", GROUP="plugdev" #CW-Lite
SUBSYSTEM=="usb", ATTRS{idVendor}=="2b3e", ATTRS{idProduct}=="ace3", MODE="0664", GROUP="plugdev" #CW1200
SUBSYSTEM=="usb", ATTRS{idVendor}=="2b3e", ATTRS{idProduct}=="c305", MODE="0664", GROUP="plugdev" #CW305 FPGA Target
SUBSYSTEM=="usb", ATTRS{idVendor}=="2b3e", ATTRS{idProduct}=="c000", MODE="0664", GROUP="plugdev" #FTDI-Based JTAG Programmer
2. Add your username to the plugdev group:
$ sudo usermod -a -G plugdev YOUR-USERNAME
3. And reset the udev system:
$ sudo udevadm control --reload-rules
4. Finally log out & in again for the group change to take effect.
5. Connect the USB cable of your device.
1. Make a file called <code>/etc/udev/rules.d/99-newae.rules</code> . The contents of this file should be:
# allow users to claim the device
SUBSYSTEM=="usb", ATTRS{idVendor}=="2b3e", ATTRS{idProduct}=="ace1", MODE="0664", GROUP="plugdev"
SUBSYSTEM=="usb", ATTRS{idVendor}=="2b3e", ATTRS{idProduct}=="ace2", MODE="0664", GROUP="plugdev" #CW-Lite
SUBSYSTEM=="usb", ATTRS{idVendor}=="2b3e", ATTRS{idProduct}=="ace3", MODE="0664", GROUP="plugdev" #CW1200
SUBSYSTEM=="usb", ATTRS{idVendor}=="2b3e", ATTRS{idProduct}=="c305", MODE="0664", GROUP="plugdev" #CW305 FPGA Target
SUBSYSTEM=="usb", ATTRS{idVendor}=="2b3e", ATTRS{idProduct}=="c000", MODE="0664", GROUP="plugdev" #FTDI-Based JTAG Programmer
2. Add your username to the plugdev group:
$ sudo usermod -a -G plugdev YOUR-USERNAME
3. And reset the udev system:
$ sudo udevadm control --reload-rules
4. Finally log out & in again for the group change to take effect.
5. Connect the USB cable of your device.
