| As of August 2020 the site you are on (wiki.newae.com) is deprecated, and content is now at rtfm.newae.com. |
Difference between revisions of "Tutorial CW305-1 Building a Project"
(Initial page layout) |
(→Target Firmware) |
||
| Line 2: | Line 2: | ||
= Target Firmware = | = Target Firmware = | ||
| + | In the ChipWhisperer examples, the Artix-7 FPGA is programmed using Verilog. This section describes how to open and build one of these projects. It also describes the layout of the AES-128 example, which is a good starting point for making new FPGA projects. | ||
| + | |||
== Opening the Project == | == Opening the Project == | ||
== FPGA Code Layout == | == FPGA Code Layout == | ||
Revision as of 08:02, 16 January 2017
The CW305 target is an FPGA target board for use with the ChipWhisperer capture hardware. This board lets you test side channel analysis techniques on an Artix-7 FPGA. With this setup, a different toolchain is required: we won't be building C firmware with a makefile. This tutorial walks through the various steps required to run an AES-128 example on the CW305 target.
Contents
Target Firmware
In the ChipWhisperer examples, the Artix-7 FPGA is programmed using Verilog. This section describes how to open and build one of these projects. It also describes the layout of the AES-128 example, which is a good starting point for making new FPGA projects.
Opening the Project
FPGA Code Layout
Building the Project
Hardware Connections
- USB for configuring target - 20 pin header - Measurement (LNA output)
Capture Setup
- Example script - Upload bitstream - Sample captures
