As of August 2020 the site you are on (wiki.newae.com) is deprecated, and content is now at rtfm.newae.com.

Difference between revisions of "CW308T-STM32F"

From ChipWhisperer Wiki
Jump to: navigation, search
Line 1: Line 1:
 
{{Infobox cw308target
 
{{Infobox cw308target
 
|name                  = CW308T-STM32F
 
|name                  = CW308T-STM32F
|image                  =  
+
|image                  = cw308_stm32f.jpg
 
|caption                =  
 
|caption                =  
 
|Target Device          = ST STM32F
 
|Target Device          = ST STM32F

Revision as of 19:27, 10 April 2017

CW308T-STM32F
Cw308 stm32f.jpg
Target Device ST STM32F
Target Architecture Cortex M0,M3,M4
Hardware Crypto Possible
Design Files

GITHub Link

OSH Park PCBs
Supported Apps Simple Serial Enc/Auth
Programmer ST-LINK/V2
Status Released

Supported Devices

The STM32F board supports several STM32F devices in the TQFP-64 package. Various solder jumpers need to bet set to either the "A" or "B" position to select appropriate VCC supply for the different series. The following table summarizes examples of suitable devices:

STM32F Series Package Device Hardware AES Tested Jumper
F0 TQFP-64 B
F1 TQFP-64 B
F2 TQFP-64 A
F3 TQFP-64 B
F4 TQFP-64 STM32F415RGT6 Yes Yes A

VCC-Int Supply

Several devices (F2, F4) have internal core voltage regulators. By default the CW308 board attempts to provide power for these pins, but the voltage may not be high enough to cause the internal regulator to disable itself. In this case you can use the VADJ regulator to ensure the internal regulator is disabled. See Targets with Internal Regulators for details.

Hardware AES

The STM32F21x, and STM32F41x/43x have hardware crypto modules (AES, DES, TDES) along with hardware hash (SHA1, MD5).

Programming Connection

The 20-pin JTAG port (J6 on CW308 Board) can be used with the ST-LINK/V2 which is a low-cost JTAG programmer.

It is also possible to use other JTAG programmers such as OpenOCD. The following command worked with an Olimex OpenOCD programmer and their OpenOCD for Windows software:

openocd 
  -f path/to/board/files/cw308.cfg 
  -c init 
  -c targets 
  -c "halt" 
  -c "flash write_image erase path/to/firmware.hex"       
  -c "verify_image path/to/firmware.hex"        
  -c "reset run" 
  -c shutdown

where the contents of cw308.cfg are

source [find interface/olimex-arm-usb-ocd-h.cfg]
source [find target/stm32f4x.cfg]
reset_config srst_only

Schematic

CW308T STM32F 02.png