Changes

Setting up the Hardware
=== Using ChipWhisperer-Lite / ChipWhisperer-Pro ===
 
# 20-Pin Header connects Multi-Target to Capture Hardware
# VOUT Connects to SMA Cable
# SMA Cable connects to 'LNA' on CHA input
 
Jumpers on the Multi-Target Victim board are as follows:
[[File:xmegajumpers_cwlite.jpg]]
 
# NO jumpers mounted in AVR Portion (JP1,JP4-6,JP28) or SmartCard Portion. Note if your multi-target board does not have JP28, the TRIG jumper for the AVR, you will have to remove the AVR from the socket.
# 3.3V IO Level (JP20 set to INT.)
# FPGAOUT is routed to XTAL1 pin of XMEGA (requires jumper wire to JP4/JP15).
# The 7.37 MHz oscillator is not connected (JP18)
# The TXD & RXD jumpers are set on the XMEGA portion (JP5, JP6)
# The TRIG jumper is set on the XMEGA portion (JP13)
# The PWR jumper is set on the XMEGA portion (JP14)
# Power measurement taken from VCC shunt (JP12)
=== Using Capture Rev 2 ===
Approved_users, bureaucrat, administrator
1,956
edits