| As of August 2020 the site you are on (wiki.newae.com) is deprecated, and content is now at rtfm.newae.com. |
Difference between revisions of "CW308T-GENERIC"
From ChipWhisperer Wiki
| Line 13: | Line 13: | ||
This shows an extreme example of mounting a board onto the victim board. The actual analysis was being done on the SAMR21R on the main board, but this provided mechanical stability to allow tacking wires onto that area. | This shows an extreme example of mounting a board onto the victim board. The actual analysis was being done on the SAMR21R on the main board, but this provided mechanical stability to allow tacking wires onto that area. | ||
| − | + | [[File:huebridge2.JPG|400px]] | |
| − | + | ||
| − | + | ||
=== Hue ATMega2564RF2R Based Bulb === | === Hue ATMega2564RF2R Based Bulb === | ||
The SPI traffic was wired out as well in this example, and a ChipWhisperer-Pro was used to trigger on SPI traffic. | The SPI traffic was wired out as well in this example, and a ChipWhisperer-Pro was used to trigger on SPI traffic. | ||
| + | |||
| + | [[File:huebulb_m2564rfr2.jpg|400px]] | ||
=== Riscure CTF Board === | === Riscure CTF Board === | ||
| Line 25: | Line 25: | ||
This example allowed both power analysis and clock glitching to be performed against the board. A small shunt resistor is soldered in-line for the VCC pin. | This example allowed both power analysis and clock glitching to be performed against the board. A small shunt resistor is soldered in-line for the VCC pin. | ||
| + | [[File:riscure_ctf.jpg|400px]] | ||
[[Category: CW308 Targets]] | [[Category: CW308 Targets]] | ||
Revision as of 07:48, 24 September 2016
This is a basic prototype board which can be used for mounting other chips on the CW308 UFO Target. It can also be used to mount small boards (see the examples for photos).
Contents
Usage
Examples
The following shows several examples of this board in use.
Hue Bridge 2.0
This shows an extreme example of mounting a board onto the victim board. The actual analysis was being done on the SAMR21R on the main board, but this provided mechanical stability to allow tacking wires onto that area.
Hue ATMega2564RF2R Based Bulb
The SPI traffic was wired out as well in this example, and a ChipWhisperer-Pro was used to trigger on SPI traffic.
Riscure CTF Board
This example allowed both power analysis and clock glitching to be performed against the board. A small shunt resistor is soldered in-line for the VCC pin.
