Difference between revisions of "CW308T-MEGARF"

Revision as of 18:21, 3 November 2016

The ChipWhisperer's AVR programmer supports this target directly. No external programmer is required.

See GIT Repo for PDF of schematic.

See GIT Repo for gerber files.

The following is the original (-01) schematic. The following changes were made in -02:

MOSI/MISO was switched on Atmel device (requires PCB fix on -01, or PCB will not work)
TST connected to ground (requires PCB fix on -01, or PCB will not work)
CLKI pull down
GPIO3 is now optionally in control of 4066 instead of being hardwired
Serial resistors added on SCK/MISO/MOSI lines

@@ Line 1: / Line 1: @@
 {{Infobox|This is a BETA target and not yet available. This wiki page will continue to be updated until release. }}
-[[File:megarf_render.png|400px]]
+[[File:meagrf_render_02.png|400px]]
-The following is the original (-01) schematic, which was never publically released. The following changes were made in -02:
+== Programming ==
+The ChipWhisperer's AVR programmer supports this target directly. No external programmer is required.
+== Schematic ==
+See GIT Repo for PDF of schematic.
+[[File:CW308T_ATMegaRF_02.png|1000px]]
+== Board Layout ==
+See GIT Repo for gerber files.
+== Historical Note ==
+The following is the original (-01) schematic. The following changes were made in -02:
 * MOSI/MISO was switched on Atmel device (requires PCB fix on -01, or PCB will not work)
@@ Line 11: / Line 27: @@
 * Serial resistors added on SCK/MISO/MOSI lines
-[[File:CW308T_ATMegaRF_01.png|1000px]]
+[[File:CW308T_ATMegaRF_01.png|200px]]
+[[Category:Targets]]
+[[Category:CW308 Targets]]