As of August 2020 the site you are on (wiki.newae.com) is deprecated, and content is now at rtfm.newae.com. |
CW308T-ESP32
CW308T-ESP32 | |
---|---|
Target Device | ESP32 |
Target Architecture | ARM |
Hardware Crypto | Yes |
The ESP32 is a super-low-cost IoT device with Bluetooth & WiFi support. This target board does not break out any of the RF capabilities, and is primarily concerned with testing portions of the device stand-alone (such as secure boot, AES hardware accelerator, etc).
SPI Buffer
This device uses a Texas Instruments TXB0104 as a SPI buffer. This is a bidirectional buffer chip, meaning you can use it in any of the following ways:
- Disable chip, allowing ESP32 to load/program the attached SPI flash chip.
- Sniff the SPI bus, but with a buffer in-line to prevent your sniffer from affecting the SPI load process (or trigger on SPI packets).
- Program the SPI chip using external programmer. To do this hold ESP32 in reset.
- Use an external SPI chip (or emulator) to load the data for the ESP32. To do this you'll have to disconnect the CS pin of the SPI chip.
The direction is detected automatically.
SPI Flash Device
The ESP32 needs an attached SPI flash. The production devices use a W25Q32BVSSIG from Winbond, but this can be difficult to find from regular distributors. If you are building your own device I suggest using ISSI IS25WP032D-JBLE which is more widely available.
A variety of other devices will not work with the bootloader, meaning you cannot easily program them. It's not known exactly what is needed (they need to support DSPI at least), but for example SST26VF016BT-104I/SN did not work.
Example Application
An example application is provided in the GIT repository in the firmware/esp32 directory. Note this hasn't yet been integrated into the full build system. This application uses hardware AES.