Approved_users, bureaucrat, administrator
1,956
edits
Changes
no edit summary
['Generic Settings', 'Auxiliary Module', 'Reset AVR/XMEGA via CW-Lite'],
['Aux Settings', 'Reset AVR/XMEGA via CW-Lite', 'Delay (Post-Arm)', 1200],
]</pre></li>
<li><p>Finally, we will set the password. You can enter the password in the Capture ''Target Settings'' tab, and see the following sort of call would set the appropriate password:</p>
<pre>capself.api.setParameter(['Target Connection', 'Go Command', u'h0px3\\n'])</pre>
<p>Note the newline is actually escaped, to set the text equivalent of what will be printed. This will result in an actual newline going out across the serial port. Set that command at some point in your script.</p>
<li>Close any open ChipWhisperer-Capture windows, and run the script as before. You should connect to the target, and be able to press ''Capture 1'' and see the correct waveform.</li>