Approved_users, bureaucrat, administrator
1,956
edits
Changes
no edit summary
This is a basic prototype board which can be used for mounting other chips on the [[CW308 UFO Target]]. It can also be used to mount small boards (see the examples for photos).
== Usage ==
== Examples ==
The following shows several examples of this board in use.
=== Hue Bridge 2.0 ===
This shows an extreme example of mounting a board onto the victim board. The actual analysis was being done on the SAMR21R on the main board, but this provided mechanical stability to allow tacking wires onto that area.
=== Hue CC2530 Based Bulb ===
The SPI traffic was wired out as well in this example, and a ChipWhisperer-Pro was used to trigger on SPI traffic.
=== Hue ATMega2564RF2R Based Bulb ===
The SPI traffic was wired out as well in this example, and a ChipWhisperer-Pro was used to trigger on SPI traffic.
=== Riscure CTF Board ===
This example allowed both power analysis and clock glitching to be performed against the board. A small shunt resistor is soldered in-line for the VCC pin.
[[Category: CW308 Targets]]