Approved_users, bureaucrat, administrator
1,956
edits
Changes
→VCC-INT Routing
There is also two banana jacks which can be connected to a 1.0V lab supply. You must be very careful to ensure you do not exceed 1.10V on this input, as beyond that range you risk damaging the FPGA.
The choice of internal/external is selected with the switch.There is a ferrite bead + large capacitors after this switch, so note that you '''cannot''' use the banana jack inputs as a voltage glitch insertion method. Instead you must insert them directly into the SMA connectors
=== SMA Connectors / Test Points ===
=== Jumper ===
=== Shunt Resistor ===
=== VCC-INT Decoupling Capacitors ===
=== VCC-AUX Shunt Resistor ===
== Shunt Selection ==