Changes

CW308T-GENERIC

999 bytes added, 13:22, 24 September 2016
no edit summary
 
This is a basic prototype board which can be used for mounting other chips on the [[CW308 UFO Target]]. It can also be used to mount small boards (see the examples for photos).
 
== Usage ==
 
 
== Examples ==
 
The following shows several examples of this board in use.
 
=== Hue Bridge 2.0 ===
 
This shows an extreme example of mounting a board onto the victim board. The actual analysis was being done on the SAMR21R on the main board, but this provided mechanical stability to allow tacking wires onto that area.
 
=== Hue CC2530 Based Bulb ===
 
The SPI traffic was wired out as well in this example, and a ChipWhisperer-Pro was used to trigger on SPI traffic.
 
=== Hue ATMega2564RF2R Based Bulb ===
 
The SPI traffic was wired out as well in this example, and a ChipWhisperer-Pro was used to trigger on SPI traffic.
 
=== Riscure CTF Board ===
 
This example allowed both power analysis and clock glitching to be performed against the board. A small shunt resistor is soldered in-line for the VCC pin.
[[Category: CW308 Targets]]
Approved_users, bureaucrat, administrator
1,956
edits