Open main menu

Changes

CW1173 ChipWhisperer-Lite/20-Pin Connector

1,337 bytes added, 17:57, 25 January 2017
Created page with "The pinout is as follows: {| class="wikitable" ! Number ! Name ! Dir ! Description |- | 1 | +VUSB (5V) | O | Not Connected on ChipWhisperer-Lite. |- | 2 | GND | O | System GN..."
The pinout is as follows:

{| class="wikitable"
! Number
! Name
! Dir
! Description
|-
| 1
| +VUSB (5V)
| O
| Not Connected on ChipWhisperer-Lite.
|-
| 2
| GND
| O
| System GND.
|-
| 3
| +3.3V
| O
| +3.3V to Target Device, can be turned off, 200mA available.
|-
| 4
| FPGA-HS1
| I/O
| High Speed Input (normally clock in).
|-
| 5
| PROG-RESET
| I/O
| Target RESET Pin (AVR Programmer).
|-
| 6
| FPGA-HS2
| I/O
| High Speed Output (normally clock or glitch out).
|-
| 7
| PROG-MISO
| I/O
| SPI input: MISO (for SPI + AVR Programmer).
|-
| 8
| VTarget
| I
| Drive this pin with desired I/O voltage in range 1.5V-5V.
|-
| 9
| PROG-MOSI
| I/O
| SPI output: MOSI (for SPI + AVR Programmer).
|-
| 10
| FPGA-TARG1
| I/O
| TargetIO Pin 1 - Usually UART TX or RX.
|-
| 11
| PROG-SCK
| I/O
| SPI output: SCK (for SPI + AVR Programmer).
|-
| 12
| FPGA-TARG2
| I/O
| TargetIO Pin 2 - Usually UART RX or TX.
|-
| 13
| PROG-PDIC
| I/O
| PDI Programming Clock (XMEGA Programmer), or CS pin (SPI).
|-
| 14
| FPGA-TARG3
| I/O
| TargetIO Pin 3 - Usually bidirectional IO for smartcard.
|-
| 15
| PROG-PDID
| I/O
| PDI Programming Data (XMEGA Programmer).
|-
| 16
| FPGA-TARG4
| I/O
| TargetIO Pin 4 - Usually trigger input.
|-
| 17
| GND
| O
|

|-
| 18
| +3.3V
| O
|

|-
| 19
| GND
| O
|

|-
| 20
| +VUSB (5V)
| O
| Not Connected on ChipWhisperer-Lite.
|}
Coflynn
Approved_users, bureaucrat, administrator
1,956
edits