Changes

<li>Under the ''Generic SettingsPython Console'' tab, as find the ''Scope Moduleconnect_cwlite_simpleserial.py'', select the ''ChipWhisperer/OpenADC'' optionscript and double-click.</li><li>Under ''Generic Settings'' tab, as Check there are no errors on the ''Target Module'', select the ''Simple Serial'' optionconnection.</li><li>Switch to Under the ''Target SettingsPython Console'' tab, and as find the ''connection'', select the ''ChipWhisperer'' (for CW1002) or ''NewAE USB (CWLite/CW1200)'' (for ChipWhisperer Lite/Pro)setup_cwlite_xmega.</li><li>Switch to the py''Scope Settings'' tab, script and ensure the ''connection'' is set to either ''ChipWhisperer'' (for CW1002) or ''NewAE USB (CWLite/CW1200)'' (for ChipWhisperer Lite/Pro)double-click.</li><li>Run the master connect (click the button labeled ''Master: DIS''). Both the Target &amp; Scope should switch to ''CON'' and be green circles.</li><li><p>For the CW1173/CW1180/Cw1200 (ChipWhisperer-Lite/Pro based systems), perform the following:</p><blockquote><ol style="list-style-type: lower-alpha;"><li>Set the ''CLKGEN'' frequency to ''7.37 MHz''</li><li>Set the ''Target HS-IO Out'' as ''CLKGEN''</li></ol></blockquote></li><li>If targetting an XMEGA board (either the ChipWhisperer-Lite XMEGA default target, or the XMEGA on the multi-target board), perform the following:<ol style="list-style-type: lower-alpha;"><li>Set ''Target IO1'' as ''Serial RXD''</li><li>Set ''Target IO2'' as ''Serial TXD''</li></ol></li>