Changes

CW308T-STM32F/ChipWhisperer Bootloader

No change in size, 03:04, 6 February 2018
no edit summary
To access the bootloader you can perform these steps. They vary based on if you have a "Rev 02" board or a "Rev 03 or Later" board. The revision number is printed on the bottom side as part of the PCB part number (STM32F-03 is Rev -03 for example).
## == Rev -03 or Later ##==
# Select the
{{Warningbox|If you get verify errors, it's possible the shunt resistor is causing power to dip too low. This can be solved by mounting a jumper between the "SH-" and "SH+" pins at J16 (to the left of the SMA connector) on the UFO board. Retry programming with the jumper mounted. }}
## == Rev -02 Boards ##==
The Rev -02 boards did not have all programming connections present. They require some additional steps:
Approved_users, bureaucrat, administrator
1,956
edits