Changes

CW303 XMEGA Target/Solder Jumpers

558 bytes added, 20:45, 12 April 2018
Created page with "== Solder Jumpers == ; SJ2 : Selects the source of the input to the VCC filter - either the 20-pin 3.3V VCC (default), or the optional voltage regulator which derives the pow..."
== Solder Jumpers ==

; SJ2
: Selects the source of the input to the VCC filter - either the 20-pin 3.3V VCC (default), or the optional voltage regulator which derives the power from a USB-Micro connector.
; SJ3
: Connects the output of the VCC filter to the XMEGA VCC network. Soldered by default.
; SJ4
: Connects the SMA Measure header to the resistive shunt. Soldered by default.
; SJ5
: Connects the SMA Glitch header to the resistive shunt. Soldered by default.
; SJ7
: Connects the VCC of the XMEGA board to VREF on 20-pin header. Soldered by default.