Approved_users, administrator
366
edits
Changes
→Programming
Next, you'll need to add a target for the TC233LP chip. Navigate to Target > Browse and hit New. Select "Use a default target configuration" and find "Application Kit with TC234 (DAS)" under "Application Kits (DAS)", then hit "Finish". Hit "Connect". If "Ready for Memtool Command" appeared next to it, everything went smoothly.
To actually program the device, open your hex file using "Open File..." on the left hand side. Click on the address beginning with <code>0xA0xA0000000</code> and hit "Add Sel.>>". Finally, hit Program press . Press the nRST button on the CW308. Current versions of the HAL will light up LED1 upon starting, so if this LED is on, your program has been successfully flashed.
== Building Projects ==