Changes

CW1101 ChipWhisperer-Nano

No change in size, 15:31, 14 October 2018
no edit summary
These versions have some limitations. First, they have not been well tested and were not built under the normal production processes, so are not guaranteed to be as reliable w.r.t. soldering. Second, they have some specific hardware changes relative to the production units:
# arm TechCon and CHES version (-02 01 and -03 02 PCB revs): If you cut/snap the target off, the GPIO4 (trigger) pin is not connected. As this pin is required to be used for the ADC trigger, we recommend not cutting the targets off these versions. The GPIO4 trace is incorrectly routed THROUGH the target section. If you'd like to use an external target, either erase the STM32F0 or remove the IC.# CHES version (-02 01 PCB rev) does not have the amplifier on the front-end. This results in poor analog performance.
Approved_users, bureaucrat, administrator
1,956
edits