Changes

no edit summary
=== Using ChipWhisperer-Lite / ChipWhisperer-Pro ===
 
# 20-Pin Header connects Multi-Target to Capture Hardware
# VOUT Connects to SMA Cable
# SMA Cable connects to 'LNA' on CHA input
 
Jumpers on the Multi-Target Victim board are as follows:
 
[[File:xmegajumpers_cwlite.jpg]]
 
# NO jumpers mounted in AVR Portion (JP1,JP4-6,JP28) or SmartCard Portion. Note if your multi-target board does not have JP28, the TRIG jumper for the AVR, you will have to remove the AVR from the socket.
# 3.3V IO Level (JP20 set to INT.)
# FPGAOUT is routed to XTAL1 pin of XMEGA (requires jumper wire to JP4/JP15).
# The 7.37 MHz oscillator is not connected (JP18)
# The TXD & RXD jumpers are set on the XMEGA portion (JP5, JP6)
# The TRIG jumper is set on the XMEGA portion (JP13)
# The PWR jumper is set on the XMEGA portion (JP14)
# Power measurement taken from VCC shunt (JP12)
=== Using Capture Rev 2 ===
The following are specific instructions only for the ChipWhisperer-Lite or -Pro:
#From the Project menu select the Example Scripts and then ChipWhisperer-Lite: AES SimpleSerial on XMEGA# This should connect to the target board & run a few encryptions. You should check the "Encryption Status Manager" along with viewing the resulting power measurement.# Jump to the generic instructions (skip the CWC-Rev2 instructions next).
==== CW-Capture Rev2 Specific Setup ====
== Appendix B-1: Full Attack Script for older (< 3.1.x) ==
Here is the full attack script for older releases:- '''DO NOT attempt to use with a current release (3.1.8 or later)'''.
<pre># Based on Ilya Kizhvatov's work, published as &quot;Side Channel Analysis of AVR XMEGA Crypto Engine&quot;
== Appendix B-2: Full Attack Script for 0.09 or Older Releases ==
Here is the full attack scriptfor VERY old releases:
<pre># Based on Ilya Kizhvatov's work, published as &quot;Side Channel Analysis of AVR XMEGA Crypto Engine&quot;
Atmel and XMEGA are registered trademarks or trademarks of Atmel Corporation or its subsidiaries, in the US and/or other countries.
 
== Links ==
{{Template:Tutorials}}
[[Category:Tutorials]]