CW308T: Stand-Alone Simple Serial Example (AVR or XMEGA)

Board/Jumper Settings

The following specifies what various jumpers should be set to:

Switch	Setting	Note
EXT-DC Switch (S1)	ON	Can be used as on/off switch.
3.3V Source	LDO	Set VCC3.3 as coming from LDO.
3.3V LDO Source	EXT-DC	Set LDO source as DC-Power Jack.
Others	Don't Care

Jumper	Setting	Note
J3	Jumper mounted on "CRYSTAL" setting (top row of pins).	Route on-board crystal oscillator
J4	Jumper mounted on right two pins (board default).	Specifies victim board sets VREF voltage.
J14	Jumper mounted on left two pins (board default).	Uses FILT output from victim board.

X1 Crystal Socket	Note
7.37 MHz Crystal	This is default frequency for programmed software. Can use another frequency for custom programs.

With that setup done, you can proceed to the next section.

Mounting Target Board

The selected target board (AVR or XMEGA) should be placed onto the main victim area. See the CW308 UFO Target page for details.

Connecting Oscilloscope

The oscilloscope needs two connections. The trigger should be connected to GPIO4 (a test point is provided for this), and the measurement should be done via the SMA J17 (marked VOUT). Note you can also use test point TP5 with a regular oscilloscope probe, but it will provide much worse performance.

The oscilloscope should be set to AC-coupled mode to eliminate the constant DC offset.

USB Serial Usage