Approved_users
510
edits
| As of August 2020 the site you are on (wiki.newae.com) is deprecated, and content is now at rtfm.newae.com. |
Changes
Fixed broken image link
In addition the VCC glitcher board must be mounted, which means removing the jumpers on the 6-pin header around the AVR. Also the 'IN' pin on the VCC glitcher board connected to the FPGAOUT pin. This is done via a jumper wire. Both of these are shown in the following figure:
<blockquote>[[File:vccglitcher_routing.jpg|frame|none|alt=|caption The control line for the VCC glitcher board comes from the FPGAOUT pin.]]
[[File:vccglitcher_mounted.jpg|frame|none|alt=|caption The VCC glitcher board must be mounted with <code>GND</code> at the bottom matching, exactly as shown here.]]
</blockquote>
== Setting up Glitch Example ==
<blockquote><p>[[File:glitchexample-capsetupclkgen.png|image]]</p></blockquote></li>
<li><p>Check the box marked ''HS-Glitch Out Enable (Low Power)'':</p>
<blockquote><p>[[File:glitchexample-capsetup2bcapsetup2B.png|image]]</p></blockquote></li></ol>
</blockquote></li>
<li><p>For the ChipWhisperer-Capture Rev 2 (CW1002):</p>
