Approved_users
510
edits
| As of August 2020 the site you are on (wiki.newae.com) is deprecated, and content is now at rtfm.newae.com. |
Changes
→Basic Usage Instructions
|content= CW1173_ChipWhisperer-Lite/20-Pin Connector}}
{{CollapsibleSection|intro = == 8-Pin SmartCard Connector == The CW1173 contains two 8-pin connectors, which use our standard 8-pin Smart-Card header pinout. One header connects to the SAM3U device (which has ISO-7816 drivers), one header connects to the FPGA. Note there is currently no firmware support for these devices, but the hardware is designed for any of the following: * Emulating a smart card (use interposer board), or fuzzing a smart card reader* Communicating to a smart card* Sniffing traffic between a legitimate reader and smart card* Side-channel analysis of smart card device Header J7 (Connects to SAM3U): {| classcontent="wikitable"! Number! Name! Dir! Description|CW1173_ChipWhisperer-| 1| VCCIO| O| 3.3V Supply (from linear regulator, always on)|-| 2| GND| O| System GND|-| 3| RST| ILite/O| Reset (SAM3U: PA3)|8-| 4| PRESENT| I| Used to detect presence of smart card (SAM3U: PA2)|-| 5| CLK| I/O| Clock (SAM3U: PA25, 'CLK2'. FPGA: P131)|-| 6| I/O| I/O| I/O Line (SAM3U: PA22), 10k pull-up|-| 7| AUX1| I/O| Spare line (SAM3U: PA4)|-| 8| AUX2| I/O| Spare line (SAM3U: PA5)|Pin SmartCard Connector} Header J6 (Connects to FPGA): {| class="wikitable"! Number! Name! Dir! Description|-| 1| VCCIO| O| 3.3V Supply (from FPGA supply)|-| 2| GND| O| System GND|-| 3| RST| I/O| Reset (FPGA: P102)|-| 4| PRESENT/VPP| I| Not Connected (mount R60 to connect to P101)|-| 5| CLK| I/O| Clock (FPGA: P100)|-| 6| I/O| I/O| I/O Line (FPGA: P99), 10k pull-up|-| 7| AUX1| I/O| Spare line (FPGA: P98)|-| 8| AUX2| I/O| Spare line (FPGA: P97)|}
== Upgrading SAM3U Firmware ==
