As of August 2020 the site you are on (wiki.newae.com) is deprecated, and content is now at rtfm.newae.com.

Changes

Jump to: navigation, search

CW303 XMEGA Target

2,198 bytes removed, 19:49, 29 July 2020
no edit summary
{{Infobox cw308target|name = CW-Lite XMEGA Target|image = File:Cwlite-xmega.jpg|caption Page Moved = |Target Device = Atmel XMEGA128|Target Architecture = 8-bit Harvard|Hardware Crypto = Possible|Purchase Hardware = |Supported Applications = [[SimpleSerial | Simple Serial Enc/Auth]]|Programmer = CW Integrated (PDI)|Status = Released}}The ChipWhisperer-Lite board has a break-away target board section. This target can be used attached to the CW-Lite or separated and connected via ribbon cable. The breakaway target board has a slightly different feature set than the CW308T-XMEGA target board.
== LEDs == The two LEDs on the XMEGA board are active-low, which is done to reduce the impact on power consumption in the VCC power signature. The connections are as followsSee [https: {| class="wikitable"! Item! Connection! Note|-| LED9| PORTA//rtfm.5| Active low|-| LED10| PORTAnewae.6| Active low|} == Connectors == The following shows several of the connectors available on the CW301. ; 20-Pin Connector: J2 is a 20-pin connector, which uses the standard com/Targets/CW303%20XMEGA/ NewAE 20-pin connector pinoutRTFM Page]. See the ChipWhisperer-Lite documentation for details.; SMA Glitch: The SMA glitch connector allows VCC glitches be inserted into the VCC pin. This is done by shorting the resistive shunt R66. By default it connects previous content on this wiki has been moved to the SMA measure connector, but can be disconnected with the solder jumpersabove link.; SMA Measure: The SMA measure connector allows power measurements See wiki history if you would like to be taken across resistive shunt R66. By default it connects to the SMA glitch connector, but can be disconnected with the solder jumpers.; JP13: JP13 provides a pinout with several extra pins from the XMEGA device. == Solder Jumpers == ; SJ2: Selects the source view exact older versions of the input to the VCC filter - either the 20-pin 3this page.3V VCC (default), or the optional voltage regulator which derives the power from a USB-Micro connector.; SJ3: Connects the output of the VCC filter to the XMEGA VCC network. Soldered by default.; SJ4: Connects the SMA Measure header to the resistive shunt. Soldered by default.; SJ5: Connects the SMA Glitch header to the resistive shunt. Soldered by default.; SJ7: Connects the VCC of the XMEGA board to VREF on 20-pin header. Soldered by default. == Schematic == [[File:Cw303_schematic.png|image]] {{Template:Hardware}} [[Category:Targets]]
Coflynn
Approved_users, bureaucrat, administrator
1,956
edits
Retrieved from "http://wiki.newae.com/Special:MobileDiff/2977...4203"

Navigation menu