458
edits
| As of August 2020 the site you are on (wiki.newae.com) is deprecated, and content is now at rtfm.newae.com. |
Changes
no edit summary
|}
== Using Arduino Software ==
If you wish to use the Arduino software with the NOTDuino board, there is two main methods of doing that:
# Using board entirely stand-alone.
=== Using ChipWhisperer-Lite as Programmer ===
If using the board with the ChipWhisperer-Lite attached (i.e. using the ChipWhisperer-Lite as the capture hardware), this requires the fewest modifications. To use the board you will need to:
</li></ol>
=== Using Board Entirely Stand-Alone ===
If using the board stand-alone, you will need to perform the following:
<li>Connect a USB-Serial adapter to JP4. You can connect the VCC line of a serial port to the "+3v3" line, as the board can be powered from 5V '''when not connected to the ChipWhisperer-Lite'''. Never connect the board to a 5V line with the ChipWhisperer-Lite attached, as it will ''destroy the ChipWhisperer-Lite''.</li></ol>
== Kit Assembly ==
The Notduino kit includes all the parts to assemble the Notduino kit. The following shows the kit parts:
[[File:Kit_packaged.jpg|image]]
=== Kit Parts ===
Which you can break out into the following parts:
[[File:Resistors.jpg|image]]
=== Assembly Process ===
There is no specific assembly procedure for the board. The values of components have been marked on the blank PCB, here are some general instructions for the assembly process:
# The test-points (including the "GND") can be made using a cut-off resistor lead. This gives you something to clip a test point onto.
=== Assembly Video ===
You can see a [http://www.youtube.com/watch?v=zCmWzpyEYe8&hd=1 Video] of the assembly process of YouTube:
[[File:Cw304asm.png|link=http://www.youtube.com/watch?v=zCmWzpyEYe8&hd=1]]
== Troubleshooting ==
=== Programming a New Notduino AVR ===
Some users have had trouble programming fresh Notduinos from the ChipWhisperer-Lite: attempting to read the AVR's signature or program it causes the program to time out (with the message <code>USBError: [Errno 110] Operation timed out</code>). This is generally because the ChipWhisperer-Lite can't generate a clock speed slow enough to program a fresh AVR. See [https://www.newae.com/forum/viewtopic.php?f=6&t=174 this forum thread] for the problem symptoms, and [https://www.newae.com/forum/viewtopic.php?f=6&t=67 this thread] for the solution.
== Schematic ==
[[File:Cw304_schematic.png|image]]
