| As of August 2020 the site you are on (wiki.newae.com) is deprecated, and content is now at rtfm.newae.com. |
Difference between revisions of "CW308T-ADUCM3029"
| Line 1: | Line 1: | ||
{{Infobox cw308target | {{Infobox cw308target | ||
|name = CW308T-ADUCM3029 | |name = CW308T-ADUCM3029 | ||
| − | |image = | + | |image = CW308T_ADuCM3029.PNG |
|caption = | |caption = | ||
| − | |Target Device = | + | |Target Device = ADuCM3029 |
|Target Architecture = | |Target Architecture = | ||
|Hardware Crypto = Yes | |Hardware Crypto = Yes | ||
|Purchase Hardware = | |Purchase Hardware = | ||
| − | |Design Files = | + | |Design Files = |
| − | + | ||
| − | + | ||
|Supported Applications = | |Supported Applications = | ||
|Status = In Developement | |Status = In Developement | ||
Revision as of 11:20, 22 August 2018
| CW308T-ADUCM3029 | |
|---|---|
 | |
| Target Device | ADuCM3029 |
| Hardware Crypto | Yes |
| Status | In Developement |
This board supports the Analog Devices ADuCM3029 microcontroller. The mounted chip is the ADUCM3029BCPZ.
Power Supply
The ADuCM3029 can run from a core supply voltage between 1.8 and 3.3 volts. By default the core is fed from the 3.3v supply but the adjustable regulator on the CW308T can be used to set any viable core voltage. Sometimes power analysis is more viable at different supply voltages.
Cryptographic Accelerator
As described in the ADuCM3027/3029 Data Sheet[1], The cryptographic accelerator is a 32-bit APB DMA capable peripheral. There are two 32-bit buffers provided for data input/output operations. These buffers read in or read out 128 bits in four data accesses. Big endian and little endian data formats are supported, as are the following modes:
- Electronic code book (ECB) mode—
- AES mode (128 and 256)
- Counter (CTR) mode
- Cipher block chaining (CBC) mode
- Message authentication code (MAC) mode
- Cipher block chaining-message authentication code (CCM/CCM) mode
- SHA-256 mode
Programming
The ADuCM3029 supports a serial bootloader which is enabled by pulling down the PDIC pin on the CW308T. Details for using the serial bootloader can be found in the application note EE-381[2]. Single wire debug (SWD) is also supported for programming and debugging.
Schematic and Layout
See GIT Repo for design files.
