Open main menu

Changes

CW308T-AURIX

2,246 bytes removed, 19:36, 29 July 2020
Replaced content with "== Page Moved == See [https://rtfm.newae.com/Targets/UFO%20Targets/CW308T-AURIX/ NewAE RTFM Page] which is now built from the [https://github.com/newaetech/chipwhisperer-..."
{{Infobox cw308target|name = CW308T-AURIX|image = [[File:CW308T_AURIX.PNG|400px]]|caption Page Moved = |Target Device = Infineon TC233LP|Target Architecture = |Hardware Crypto = Yes|Purchase Hardware = |Design Files =|Supported Applications = |Status = In Developement}}
This board supports See [https://rtfm.newae.com/Targets/UFO%20Targets/CW308T-AURIX/ NewAE RTFM Page] which is now built from the Infineon TC233LP microcontroller[https://github.com/newaetech/chipwhisperer-target-cw308t GIT Repo].
== Power Supply == The core of the TC233LP chip runs from a 1.3v supply that is generated from an previous content on-board regulator. The I/O buses are supplied with 3.3v.== Security Features ==The TC233LP this wiki has an additional Lockstep core that runs the same instructions as the Master core (CPU0). The outputs of these cores are compared and mismatches are reported in the Safety Management Unit of the chip. This feature can only be enabled by editing the boot header of the resulting hex file.  == Programming ==Programming of the AURIX board can currently only be done over JTAG with the Infineon DAP miniWiggler v3 using Infineon Memtool. To program the AURIX chip, begin by plugging in the miniWiggler been moved to J6 on the CW308 boardabove link. Next, open Memtool. Next, See wiki history if you'll need would like to add a target for the TC233LP chip. Navigate to Target > Browse and hit New. Select "Use a default target configuration" and find "Application Kit with TC234 (DAS)" under "Application Kits (DAS)", then hit "Finish". Hit "Connect". If "Ready for Memtool Command" appeared next to it, everything went smoothly. To actually program the device, open your hex file using "Open File..." on the left hand side. Click on the address beginning with <code>0xA</code> and hit "Add Sel.>>". Finally, hit Program press the nRST button on the CW308. Current view exact older versions of the HAL will light up LED1 upon starting, so if this LED is on, your program has been successfully flashed. == Building Projects == == Modifying Boot Header ==To access some features of the TC233LP, such as the Lockstep control and disabling boot pins, the boot header at the beginning of the hex file must be modified. One way to do this is to use the "Edit" button in Memtool. After selecting the first memory range (should begin with 0xA0000000), hit "Edit". Most of the important settings are in the final 2 bytes of the second word (address 0xA0000004).  After modifying the boot header, you'll need to calculate the CRC32 of the header for addresses 0xA0000000 to 0xA0000017, as well as its compliment.== Schematic and Layout == See GIT Repo for design filespage. == Hardware == {{Template:Hardware}}[[Category:CW308 Targets]]
Coflynn
Approved_users, bureaucrat, administrator
1,956
edits