| As of August 2020 the site you are on (wiki.newae.com) is deprecated, and content is now at rtfm.newae.com. |
Difference between revisions of "CW308T-MEGARF"
From ChipWhisperer Wiki
(→Historical Note) |
|||
| Line 19: | Line 19: | ||
== Historical Note == | == Historical Note == | ||
| − | The following is the original (-01) schematic. The following changes were made in -02: | + | The following is the original (-01) schematic. The -01 PCBs were never publicly released and used during development only. The following changes were made in -02: |
* MOSI/MISO was switched on Atmel device (requires PCB fix on -01, or PCB will not work) | * MOSI/MISO was switched on Atmel device (requires PCB fix on -01, or PCB will not work) | ||
Revision as of 19:21, 3 November 2016
Programming
The ChipWhisperer's AVR programmer supports this target directly. No external programmer is required.
Schematic
See GIT Repo for PDF of schematic.
Board Layout
See GIT Repo for gerber files.
Historical Note
The following is the original (-01) schematic. The -01 PCBs were never publicly released and used during development only. The following changes were made in -02:
- MOSI/MISO was switched on Atmel device (requires PCB fix on -01, or PCB will not work)
- TST connected to ground (requires PCB fix on -01, or PCB will not work)
- CLKI pull down
- GPIO3 is now optionally in control of 4066 instead of being hardwired
- Serial resistors added on SCK/MISO/MOSI lines
