As of August 2020 the site you are on (wiki.newae.com) is deprecated, and content is now at rtfm.newae.com.

Difference between revisions of "CW308T-STM32F"

From ChipWhisperer Wiki
Jump to: navigation, search
(Programming Connection)
(Replaced content with "== Page Moved == See [https://rtfm.newae.com/Targets/UFO%20Targets/CW308T-STM32F/ NewAE RTFM Page] which is now built from the [https://github.com/newaetech/chipwhisperer...")
 
(67 intermediate revisions by 4 users not shown)
Line 1: Line 1:
{{Infobox cw308target
+
== Page Moved ==
|name                  = CW308T-STM32F
+
|image                  =  
+
|caption                =  
+
|Target Device          = ST STM32F
+
|Target Architecture    = Cortex M0,M3,M4
+
|Hardware Crypto        = Possible
+
|Purchase Hardware      =
+
|Design Files          = [https://github.com/newaetech/chipwhisperer/tree/master/hardware/victims/cw308_ufo_target/stm32f GITHub Link]
+
  
|Supported Applications = [[SimpleSerial | Simple Serial Enc/Auth]]
+
See [https://rtfm.newae.com/Targets/UFO%20Targets/CW308T-STM32F/ NewAE RTFM Page] which is now built from the [https://github.com/newaetech/chipwhisperer-target-cw308t GIT Repo].
|Programmer            = ST-LINK/V2
+
|Status                = Released
+
}}
+
  
== Supported Devices ==
+
The previous content on this wiki has been moved to the above link. See wiki history if you would like to view exact older versions of this page.
 
+
The STM32F board supports several STM32F devices in the TQFP-64 package. Various solder jumpers need to bet set to either the "A" or "B" position to select appropriate VCC supply for the different series. The following table summarizes examples of suitable devices:
+
{| class="wikitable"
+
!STM32F Series
+
!Package
+
!Device
+
!Hardware AES
+
!Tested
+
!Jumper
+
|-
+
|F0
+
|TQFP-64
+
|
+
|
+
|
+
|B
+
|-
+
|F1
+
|TQFP-64
+
|
+
|
+
|
+
|B
+
|-
+
|F2
+
|TQFP-64
+
|
+
|
+
|
+
|A
+
|-
+
|F3
+
|TQFP-64
+
|
+
|
+
|
+
|B
+
|-
+
|F4
+
|TQFP-64
+
|STM32F415RGT6
+
|Yes
+
|Yes
+
|A
+
|}
+
 
+
=== VCC-Int Supply ===
+
Several devices (F2, F4) have internal core voltage regulators. By default the CW308 board attempts to provide power for these pins, but the voltage may not be high enough to cause the internal regulator to disable itself. In this case you can use the VADJ regulator to ensure the internal regulator is disabled. See [[Targets with Internal Regulators]] for details.
+
 
+
== Hardware AES ==
+
 
+
The STM32F21x, and STM32F41x/43x have hardware crypto modules (AES, DES, TDES) along with hardware hash (SHA1, MD5).
+
 
+
== Programming Connection ==
+
 
+
The 20-pin JTAG port (J6 on CW308 Board) can be used with the [https://www.digikey.com/product-detail/en/stmicroelectronics/ST-LINK-V2/497-10484-ND/2214535 ST-LINK/V2] which is a low-cost JTAG programmer.
+
 
+
It is also possible to use other JTAG programmers such as OpenOCD. The following command worked with an Olimex OpenOCD programmer and their [https://www.olimex.com/Products/ARM/JTAG/ARM-USB-OCD-H/ OpenOCD for Windows] software:
+
<pre>
+
openocd
+
  -f path/to/board/files/cw308.cfg
+
  -c init
+
  -c targets
+
  -c "halt"
+
  -c "flash write_image erase path/to/firmware.hex"     
+
  -c "verify_image path/to/firmware.hex"       
+
  -c "reset run"
+
  -c shutdown
+
</pre>
+
where the contents of <code>cw308.cfg</code> are
+
<pre>
+
source [find interface/olimex-arm-usb-ocd-h.cfg]
+
source [find target/stm32f4x.cfg]
+
reset_config srst_only
+
</pre>
+
 
+
== Schematic ==
+
[[File:CW308T_STM32F_02.png|1100px]]
+
 
+
 
+
[[Category: CW308 Targets]]
+

Latest revision as of 12:34, 29 July 2020

Page Moved

See NewAE RTFM Page which is now built from the GIT Repo.

The previous content on this wiki has been moved to the above link. See wiki history if you would like to view exact older versions of this page.