CW308T-STM32F

CW308T-STM32F
Target Device	ST STM32F
Target Architecture	Cortex M0,M3,M4
Hardware Crypto	Possible
Design Files	GITHub Link OSH Park PCBs
Supported Apps	Simple Serial Enc/Auth
Programmer	ST-LINK/V2
Status	Released

Supported Devices

The STM32F board supports several STM32F devices in the TQFP-64 package. Various solder jumpers need to bet set to either the "A" or "B" position to select appropriate VCC supply for the different series. The following table summarizes examples of suitable devices:

STM32F Series	Package	Device	Hardware AES	Tested	Jumper
F0	TQFP-64				B*
F1	TQFP-64				B
F2	TQFP-64				A
F3	TQFP-64				B
F4	TQFP-64	STM32F415RGT6	Yes	Yes	A

* The F0 variant has a slightly different pinout, as has less VCC/GND pins and more I/O pins than other devices. The result is several I/O pins cannot be used as they are tied to VCC/GND. This will NOT affect regular usage. See details below.

VCC-Int Supply

Several devices (F2, F4) have internal core voltage regulators. By default the CW308 board attempts to provide power for these pins, but the voltage may not be high enough to cause the internal regulator to disable itself. In this case you can use the VADJ regulator to ensure the internal regulator is disabled. See Targets with Internal Regulators for details.

Hardware AES

The STM32F21x, and STM32F41x/43x have hardware crypto modules (AES, DES, TDES) along with hardware hash (SHA1, MD5).

Programming Connection

The 20-pin JTAG port (J6 on CW308 Board) can be used with the ST-LINK/V2 which is a low-cost JTAG programmer.

It is also possible to use other JTAG programmers such as OpenOCD. The following command worked with an Olimex OpenOCD programmer and their OpenOCD for Windows software:

openocd 
  -f path/to/board/files/cw308.cfg 
  -c init 
  -c targets 
  -c "halt" 
  -c "flash write_image erase path/to/firmware.hex"       
  -c "verify_image path/to/firmware.hex"        
  -c "reset run" 
  -c shutdown

where the contents of cw308.cfg are

source [find interface/olimex-arm-usb-ocd-h.cfg]
source [find target/stm32f4x.cfg]
reset_config srst_only

Example Projects

WARNING: The current example projects are built for the -01 rev of the PCB. The only change is the trigger pin has changed, you will need to modify the stm32f4 HAL file to reflect the trigger is now PA12 (-02 version) instead of PA11 (-01 version).

Schematic