| As of August 2020 the site you are on (wiki.newae.com) is deprecated, and content is now at rtfm.newae.com. |
Difference between revisions of "CW308T-STM32F/ChipWhisperer Bootloader"
From ChipWhisperer Wiki
| Line 19: | Line 19: | ||
# Reset the ARM device either by pressing the reset button (newer UFO boards only), or by toggling power: | # Reset the ARM device either by pressing the reset button (newer UFO boards only), or by toggling power: | ||
#: [[File:arm_togglepower.png]] | #: [[File:arm_togglepower.png]] | ||
| + | |||
| + | {{Warningbox|If you get verify errors, it's possible the shunt resistor is causing power to dip too low. This can be solved by mounting a jumper between the "SH-" and "SH+" pins at J16 (to the left of the SMA connector) on the UFO board. Retry programming with the jumper mounted. }} | ||
Revision as of 08:13, 18 July 2017
The STM32Fx devices have a built-in bootloader, and the ChipWhisperer software as of 3.5.2 includes support for this bootloader.
Important notes before we begin:
- You MUST setup a clock and the serial lines for the chip. This is easily done by selecting a start-up script such as the "AES SimpleSerial on XMEGA" startup script.
- On the STM32F1, you MUST adjust the clock frequency to by 8MHz. The bootloader does not work with our usual 7.37 MHz clock frequency.
To access the bootloader you can perform these steps:
- Select the
-
- Mount a jumper between the H1/H2 pins on the UFO board:
-
- Reset the ARM device either by pressing the reset button (newer UFO boards only), or by toggling power:
-
- Select the hex-file and press the "Program/Verify" button.
- The device should program, it may take a moment to fully program/verify on larger devices:
-
- Remove the jumper between the H1/H2 pins.
- Reset the ARM device either by pressing the reset button (newer UFO boards only), or by toggling power:
-
If you get verify errors, it's possible the shunt resistor is causing power to dip too low. This can be solved by mounting a jumper between the "SH-" and "SH+" pins at J16 (to the left of the SMA connector) on the UFO board. Retry programming with the jumper mounted.
