Changes

CW308T: Stand-Alone Simple Serial Example (AVR or XMEGA)

250 bytes added, 14:43, 1 May 2018

no edit summary

[[File:P1090078.jpg|~~600px~~600x600px|Example of attaching to the AVR target device.]]

== Board/Jumper Settings ==

The following specifies what various jumpers should be set to:

{| class="wikitable"

!style="width: 150px;"|Switch!style="width: 300px;"|Setting!style="width: 200px;"|Note

|-

|EXT-DC Switch (S1)

|}

{| class="wikitable"

!style="width: 150px;"|Jumper!style="width: 300px;"|Setting!style="width: 200px;"|Note

|-

|J3

|}

{| class="wikitable"

!style="width: 150px;"|X1 Crystal Socket!style="width: 500px;"|Note

|-

|7.37 MHz Crystal

== USB Serial Usage ==

~~[[File:P1090080.jpg|thumb|600x600px|Details of a possible oscilloscope connection on the trigger pin, along with a USB-serial on GPIO1/GPIO2.]]~~A serial connection is needed on GPIO1/GPIO2. This can be provided by any 3.3V USB-Serial cable (DO NOT use a cable which outputs either RS232 levels, or 5V levels). [[File:P1090080.jpg|600x600px|Details of a possible oscilloscope connection on the trigger pin, along with a USB-serial on GPIO1/GPIO2.]]

This can either be connected at J1 (the 20-pin ChipWhisperer header), or the pin headers directly beside the victim board. The pin headers do not provide diode clamping, where as the connections at J1 have diode clamping.

[[Category: CW308 Targets]]