Changes

no edit summary
[[File:P1090078.jpg|thumb|600x600px|Example of attaching to the AVR target device.]]
== Board/Jumper Settings ==
== USB Serial Usage ==
[[File:P1090080.jpg|thumb|600x600px|Details of a possible oscilloscope connection on the trigger pin, along with a USB-serial on GPIO1/GPIO2.]]A serial connection is needed on GPIO1/GPIO2. This can be provided by any 3.3V USB-Serial cable (DO NOT use a cable which outputs either RS232 levels, or 5V levels).
This can either be connected at J1 ([[File:P1090080.jpg|600x600px|Details of a possible oscilloscope connection on the 20-trigger pin ChipWhisperer header), or the pin headers directly beside the victim board. The pin headers do not provide diode clamping, where as the connections at J1 have diode clampingalong with a USB-serial on GPIO1/GPIO2.]]
This can either be connected at J1 (the 20-pin ChipWhisperer header), or the pin headers directly beside the victim board. The pin headers do not provide diode clamping, where as the connections at J1 have diode clamping.
[[Category: CW308 Targets]]