The CW308 UFO Board is a handy main-board for attacking all sorts of embedded targets. Released in 2016, it forms the basis for most of our upcoming target boards. It can be used stand-alone (with an oscilloscope) or with the ChipWhisperer-Capture hardware.== Page Moved ==
== Overview == == Victim Board Connectors == The "victim board" fits into three 20-pin female headers. They provide both electrical and mechanical connections for the board. There is optional mounting holes which can be used if additional mechanical support is required (especially if you need a locked-down victim for use with an EM probe). The following shows the dimensions of the main connector: See [[Filehttps:CW308_victim_dims//rtfm.png|left|518x518px|The CW308 victim board has contacts on a 100 mil spacing, allowing you to use regular prototype boardsnewae. Click for full size.]] == Icom/O Connections == There are two main ITargets/O connection points: the pin headers which duplicate the target board connections, and the 20-pin ChipWhisperer headerCW308%20UFO/ NewAE RTFM Page]. The ChipWhisperer header pins (most of the pins previous content on header J5) have diode protection this wiki has been moved to set a maximum voltage level. The maximum voltage is set by the voltage present on the middle pin of J4above link. == Clock Network == === Clock Selection === === Crystal Driver === == Power Distribution == === External Power Sources === === On-Board LDOs === == Programmer Connections == == Jumper Summary == == Schematic == The schematic is available in PDF format here: . The following has a copy See wiki history if you would like to view exact older versions of schematic pages in image as well: [[File:NAE-CW308-03_Schematic_Page_1this page.png|1200px]] [[File:NAE-CW308-03_Schematic_Page_2.png|1200px]] [[File:NAE-CW308-03_Schematic_Page_3.png|1200px]] [[File:NAE-CW308-03_Schematic_Page_4.png|1200px]] [[File:NAE-CW308-03_Schematic_Page_5.png|1200px]]