As of August 2020 the site you are on (wiki.newae.com) is deprecated, and content is now at rtfm.newae.com.

Changes

Jump to: navigation, search

CW506 Advanced Breakout Board

99 bytes added, 11:11, 7 June 2016
SW4 (Target Disconnect)
A DIP switch can be used to disconnect certain pins of the 20-pin header. The DIP switch has small text marked "ON", when the DIP switch is moved to this position the 20-pin connector is ENABLED.
The following shows an example where we've disconnected GPIO4 (the trigger) from our target device, and am feeding an external trigger in with the header (JP4) to the left of the DIP switch. This new trigger signal will be routed to the attached ChipWhisperer, and can be used instead of the trigger coming from the target device. Notice the DIP switch for GPIO4 (TIO4) is set to the LEFT, and the rest are set to the RIGHT (ON).
[[File:cw506_dip_nogpio4.jpg|600px400px]]
=== VCC-IO Settings ===
Approved_users, bureaucrat, administrator
1,956
edits

Navigation menu