This tutorial uses the [[CW1200_ChipWhisperer-Pro]] hardware.
<b>TODO: add in extra # Remove the ChipWhisperer-Pro main capture hardware steps for CW 1200<, UFO Board, and SMA cable from the ChipWhisperer-Pro case.# Attached the UFO board to the ChipWhisperer-Pro with the 20-pin cable, and connect the '''VOUT''' SMA connector to the '''MEASURE''' input.# Power up the ChipWhisperer-Pro with the 5V DC power adapter, and connect the USB cable to the computer.# If this the first time powering up, you will need to install the drivers (see [[CW1200_ChipWhisperer-Pro]]). [[File:cwpro_setup.jpg]] Note if you have modified the UFO board the jumpers may no longer be at default locations. The jumper settings required are: [[File:cwpro_ufo_setup.jpg]] # XMEGA Target board mounted# J3 routes HS2/b>OUT to CLKIN# J1 set to "J5-VREF" (right two pins shorted)# J14 set to "FILT" (left two pins shorted)# "3.3V SRC" switch set to "J1/CW"
{{:Setting up Software for B1}}
