Changes

CW308T-STM32F

17 bytes added, 16:27, 25 April 2017
Running ST Example with ST-Link
=== Running ST Example with ST-Link ===
Once you've built a binary to load onto the target, you're ready to program it. Plug your programmer into the 20 pin JTAG connector (J6 on the UFO board):
 [[File:Stm32-jtag.jpg]]
Then, the details of this step will depend on your programmer. If you're using an ST-Link programmer, open the ST-Link utility and connect to the device:
 
[[File:Stm32-connect.png]]
Load your `.hex` file and program the device with the Program and Verify button:
 
[[File:Stm32-program.png]]
Approved_users
510
edits