Changes

Tutorial B2 Viewing Instruction Power Differences

22 bytes added, 21:02, 16 May 2017
Capturing Power Traces
At this point you've completed the same amount of information as the previous tutorial. The following section describes how to setup the analog capture hardware, which is new (to you). The following is entirely done in the ''Scope Settings'' tab:
[[File:cap101_trigger_setupxcf.pngPNG|image]]
<ol start="11" style="list-style-type: decimal;">
<li>Under ''Trigger Setup'' set the ''Mode'' to ''rising edge''. This means the system will trigger on a rising edge logic level:</li></ol>
[[File:cap202_CW_Extra.pngPNG|image]]
<ol start="12" style="list-style-type: decimal;">