Changes

Completing Tutorial with CW1200

719 bytes added, 03:50, 20 May 2017
no edit summary
This tutorial uses the [[CW1200_ChipWhisperer-Pro]] hardware.
 
# Remove the ChipWhisperer-Pro main capture hardware, UFO Board, and SMA cable from the ChipWhisperer-Pro case.
#Attached the UFO board to the ChipWhisperer-Pro with the 20-pin cable, and connect the '''VOUT''' SMA connector to the '''MEASURE''' input.# Power up the ChipWhisperer-Pro with the 5V DC power adapter, and connect the USB cable to the computer.# If this the first time powering up, you will need to install the drivers (see [[CW1200_ChipWhisperer-Pro]]).
[[File:cwpro_setup.jpg]]
Note if you have modified the UFO board the jumpers may no longer be at default locations. The jumper settings required are:
[[File:cwpro_ufo_setup.jpg]]
# XMEGA Target board mounted
# J3 routes HS2/OUT to CLKIN
# J1 set to "J5-VREF" (right two pins shorted)
# J14 set to "FILT" (left two pins shorted)
# "3.3V SRC" switch set to "J1/CW"
{{:Setting up Software for B1}}
Approved_users, bureaucrat, administrator
1,956
edits