Approved_users, bureaucrat, administrator
1,956
edits
Changes
no edit summary
# Connect pin 3 of UEXT (TXD) to pin 10 on the CW-Lite
# Connect pin 4 of UEXT (RXD) to pin 12 on the CW-Lite
# Connect RST (the 3 header pins soldered on) to pins 5 (nRST) and 14 (GPIO3) or 16 (GPIO4) on the CW-Lite
# Finally, attach an SMA cable between the one you added to the board and the GLITCH connector on the CW-Lite. If you'd like instead you can also use a SMA Tee to do both measurement & glitch.