Changes

CW1101 ChipWhisperer-Nano

483 bytes added, 13:00, 1 October 2018
no edit summary
# Align the holes on the edge of a hard surface (suggested: block of wood), and firmly push down on the target end while pushing against down the PCB against the edge. The objective is to avoid flexing the PCB which is likely to break components or solder joints.
# With appropriate protection from the fiberglass dust, lightly sand the broken edges.
 
== Reprogramming ==
 
To reprogram the CW1101, you simply need to force the ERASE. This is done by shorting the "ERASE" jumper on the bottom side while plugging in the USB. This is easier to do by inserting the micro-USB end into the CW1101, and leaving the full-sized end not plugged into the computer. While shorting the ERASE jumper with tweezers have someone plug in the full-sized USB. The device should re-enumerate as a serial port, and the USB LED will be off or dimmly lit.
Approved_users, bureaucrat, administrator
1,956
edits