As of August 2020 the site you are on ( is deprecated, and content is now at


From ChipWhisperer Wiki
Revision as of 11:22, 1 May 2018 by Fheubach (Talk | contribs)

Jump to: navigation, search
CC2538 Wiki.PNG
Target Device CC2538
Target Architecture ARM
Hardware Crypto Yes

The CC2538 target uses the CC2538SF53 from TI.

Building Chipwhisperer Programs

The regular firmware build process will work once the updated build system is released, utilizing a HAL module. Firmware for the device was pulled from the CC2538 Foundation Firmware, while the code to provide startup instructions and memory mapping was pulled and modified from the STM32F2 HAL. Once released, it will build with all of the SimpleSerial projects. To build:


Assuming the build works, the file size and platform will be printed.


An external programmer is needed for this target. It has currently only been tested with the TMS320-XDS100v3+ JTAG debugger through TI's Code Composer Studio v7 (CCS). To upload through CCS, create a new CCS project. There, select the CC2538SF53 as the target. To make your search easier, CC2538SF53 is a SimpleLink Wireless MCU. For Connection, select Texas Instruments XDS100v3 USB Debug Probe. Pick any unused project name and hit Finish.

CCS New Project.PNG

Next, go to Run->Debug Configurations. Right click "Code Composer Studio - Device Debugging" and hit "New".

CCS Debug New.png

Under Main, click "Use default target configuration". Next, go to program, hit "File System", and navigate to your binary. If you built using Chipwhisperer's build system, you want the .elf file from this process. Hit "Apply", then "Debug". If the target does not connect, go to Run->Connect Target. Finally, go to Run->Resume to start the program. Closing CCS should leave the program running on the CC2538.

CCS Debug Main Opt.PNG


See GIT Repo for PDF of schematic.

CW308T-CC2538-01 schematic Page 1.png

CW308T-CC2538-01 schematic Page 2.png

Board Layout

See GIT Repo for gerber files.