As of August 2020 the site you are on ( is deprecated, and content is now at

Difference between revisions of "CW508 SMA Analog Filters"

From ChipWhisperer Wiki
Jump to: navigation, search
Line 17: Line 17:
== Hardware ==

Revision as of 10:28, 1 May 2018

The CW508 Analog Filters provide an easily method of filtering out noise at both low and high frequency. These two filters serve different purposes:

  • The high pass filter helps filter out low frequency noise. A common cause of this is switch-mode power supplies, which typically operate at 50 - 500 kHz.
  • The low pass filter helps remove short spikes from the traces. For example, if other peripherals are running on the target, a LPF might help remove their effects from the traces. This is especially helpful for fast hardware crypto with the slow, synchronous captures on the ChipWhisperer. It can be difficult to fix the traces afterwards with a digital filter, so it is much more helpful to use a hardware filter instead.

These filters can simply be screwed onto the front of the ChipWhisperer capture device:

Cw508 cwpro.jpg

HPF 500 KHz Response

500khzhpf 50khz 5mhz.png

500khzhpf 50khz 100mhz.png

LPF 20 MHz Response

20mhzlpf 100khz 100mhz.png