| As of August 2020 the site you are on (wiki.newae.com) is deprecated, and content is now at rtfm.newae.com. |
Difference between revisions of "CW308T-SAM4L"
| Line 1: | Line 1: | ||
{{Infobox cw308target | {{Infobox cw308target | ||
|name = CW308T-SAM4L | |name = CW308T-SAM4L | ||
| − | |image = SAM4L- | + | |image = SAM4L-top-small.jpg |
|caption = | |caption = | ||
|Target Device = Atmel SAM4L | |Target Device = Atmel SAM4L | ||
Revision as of 17:29, 30 October 2017
| CW308T-SAM4L | |
|---|---|
| File:SAM4L-top-small.jpg | |
| Target Device | Atmel SAM4L |
| Target Architecture | ARM Cortex M4 |
| Hardware Crypto | Yes |
| Supported Apps | Simple Serial Enc/Auth |
| Status | Released |
This board supports the Atmel SAM4L microcontroller. The default build has the Atmel ATSAM4LC2AA-AU, which has 128KB flash and 32KB SRAM.
Contents
Hardware AES
The SAM4L has a hardware AES module, with optional countermeasures that can be enabled.
Programming
An external programmer is needed for this target. The SAM4L has an internal bootloader you can use via an external serial port, which is not yet supported directly by the ChipWhisperer-Capture software.
JTAG Programmer
The 20-pin JTAG port (J6 on CW308 Board) can be used with the ATATMEL-ICE which is Atmel's JTAG programmer. You can use any other ARM programmer you might have as well (i.e., OpenOCD, Segger J-Link, etc).
Using Atmel SAM-BA
Atmel SAM4L has a built-in bootloader. Not this bootloader is NOT ROM-Resident - if you reprogram the device the bootloader is lost, since it is stored in flash memory. It is recommended to use an external JTAG programmer for this target, as since the bootloader is not ROM-resident it can easily be overwritten by accident (i.e., if connecting a JTAG programmer).
Schematic
See GIT Repo for PDF of schematic.
Board Layout
See GIT Repo for gerber files.
