CW308T-AVR
| CW308T-AVR | |
|---|---|
 | |
| Target Device | Atmel AVR |
| Target Architecture | 8-bit Harvard |
| Hardware Crypto | No |
I/O Connections
The pinout of this module matches the "NOTDuino" kit along with the "CW301 Multi-Target Board" routing. The following is the connection between GPIO1-4 and the I/O lines on the AVR:
| CW308 Pin | ATMega328P Pin | Notes |
|---|---|---|
| GPIO1 | PD0 (RXD) | Serial INPUT to AVR. |
| GPIO2 | PD1 (TXD) | Serial OUTPUT from AVR. |
| GPIO3 | N/C | |
| GPIO4 | PC0 | Trigger pin (mapped to ADC-port such that I/O driver power comes from AVCC). |
| CLKIN | XTAL1 | |
| CLKFB | PB0 | Can set this pin as CLKO with fuse. Useful for synchronizing to internal RC oscillator. |
| nRST | nRST (PC6) | Used by in-system-programming (ISP) interface. |
| MOSI | PB3 (MOSI) | Used by in-system-programming (ISP) interface. |
| MISO | PB4 (MISO) | Used by in-system-programming (ISP) interface. |
| SCK | PB5 (SCK) | Used by in-system-programming (ISP) interface. |
Programming Header
The 6-pin programming heading can be used with the Atmel ISP interface. The pinout of the 6-pin programming header on the main-board allows it to work with standard Atmel ISP tools:
Schematic
