CW308T-CC2538
| CW308T-CC2538 | |
|---|---|
 | |
| Target Device | CC2538 |
| Target Architecture | ARM |
| Hardware Crypto | Yes |
The CC2538 target uses the CC2538SF53 from TI.
Building Chipwhisperer Programs
The regular firmware build process will work once the updated build system is released, utilizing a HAL module. Firmware for the device was pulled from the CC2538 Foundation Firmware, while the code to provide startup instructions and memory mapping was pulled and modified from the STM32F2 HAL. Once released, it will build with all of the SimpleSerial projects. To build:
make PLATFORM=CW308_CC2538 CRYPTO_TARGET=TINYAES128C
Assuming the build works, the file size and platform will be printed.
Programming
An external programmer is needed for this target. It has currently only been tested with the TMS320-XDS100v3+ JTAG debugger through TI's Code Composer Studio v7 (CCS). To upload through CCS, create a new CCS project. There, select the CC2538SF53 as the target. To make your search easier, CC2538SF53 is a SimpleLink Wireless MCU. For Connection, select Texas Instruments XDS100v3 USB Debug Probe. Pick any unused project name and hit Finish.
Next, go to Run->Debug Configurations. Right click "Code Composer Studio - Device Debugging" and hit "New".
Under Main, click "Use default target configuration". Next, go to program, hit "File System", and navigate to your binary. If you built using Chipwhisperer's build system, you want the .elf file from this process. Hit "Apply", then "Debug". If the target does not connect, go to Run->Connect Target. Finally, go to Run->Resume to start the program. Closing CCS should leave the program running on the CC2538.
Schematic
See GIT Repo for PDF of schematic.
Board Layout
See GIT Repo for gerber files.