CW308T-S6LX9

CW308T-S6LX9
Target Device	Spartan 6 LX9
Target Architecture	FPGA
Hardware Crypto	No
Design Files	GITHub link OSH Park PCBs
Supported Apps	Simple Serial Enc
Programmer	Xilinx JTAG
Status	Released

Example Project

Known Issues

Note the -02 Revision of the PCB has swapped the markings of the CLKIN/CLKOUT. The correct pinout is:

• CLKIN connects to P84
• CLKOUT connects to P85

The CLKIN pin is a _N clock pin. If you need the _P clock pin, you can use a jumper on the CW308 board to route the clock input into the CLKOUT pin.

Programming

The ChipWhisperer will eventually support programming this target. Until then, you will need an external programmer. This is connected via JTAG to the pin headers:

Options for programmers include:

• Xilinx Platform Cable USB or USB-II (Digikey/Mouser).
• Clone JTAG programmers off AliExpress/E-Bay for low cost (search 'Xilinx JTAG').
• Digilent Inc HS1/HS2/HS3 Cables (NB: you may need separate jumper wires).

Schematic

See GIT Repo for PDF of schematic.

Board Layout

See GIT Repo for gerber files.

Old Hardware (see RTFM.NEWAE.COM for new)

3rd Party Targets	SAKURA-G Target • SASEBO-W Target
Test Equipment	PicoScope (USB Scope) • VISA Connected Oscilloscope
Obsolete	CW1002 ChipWhisperer Capture Rev2 • CW301 Multi-Target